Plane reflector:
  Is square.
  Is 18 inchs square.

Waveguide (can):
  Is round.
  Is 9.33 inchs in diameter.
  Is 15.5 inchs long.
  The back end of the waveguide is located 2.34 inchs
  above the plane reflector.


Probe:
  Is parallel to the bottom of the can.
  Is vertical with respect to earth.
  Is 5 and 29/32" from the back of the can.
  Is 3 and 11/32" long including the brass part of the N-Type
  connector.


Notes:

When using wire mesh at these frequencies use mesh that is a minimum
of 1 inch mesh.  I strongly recommend 1/4 or 1/8 inch mesh.

-m-